Booth briefing. The DJM-700 is a four channel digital mixer from the generation before the DJM-800, built around 13 Beat Effects synced to BPM plus a separate Manual Filter effecter. It has no USB connection and nothing to update from a computer: every control on it is analogue. Its support page is archived, and its own manual's troubleshooting table is the most useful thing to read before a gig on one of these.
Fast Lane
DJM-700: equipment profile
The four-channel digital mixer that came before the DJM-800, built around the same Beat Effects idea that made the DJM-600 popular, now synced tighter to BPM and paired with a Manual Filter effecter for more hands-on shaping. Digital I/O for the CDJ-1000MK2 and DVJ line, plus MIDI out so its own controls could drive other MIDI gear.
- Channels and effects
- Four-channel digital mixer, 96 kHz sampling, 24-bit A/D-D/A, 32-bit DSP mixing. Beat Effects synced to BPM (delay, echo, trans, filter, flanger, phaser, reverb, robot, crush, roll, reverse roll, uproll, downroll) plus a Manual Filter effecter.
- Ports
- 3x phono, 2x CD, 3x line (RCA), 1x mic (XLR+phone), 1x return (phone), master out (XLR+RCA), booth, rec, send (phone), digital coaxial out, MIDI out, 2x control (mini-jack), phones.
- Dimensions and weight
- 32 cm wide, 37.8 deep, 10.8 tall (12.6 × 14.9 × 4.2 in). 6.6 kg / 14.6 lb.
The things that decide your gig
The DJM-700 at a glance, each point linked to its section.
Fully analogue control. There is no firmware or driver to check.
Pioneer DJ’s support page for this model is marked "Archived." No firmware or driver download is listed there, and none exists anywhere this research could reach: the DJM-700 is a fully analogue-control mixer with no USB connection and nothing to update from a computer.
13 Beat Effects plus a separate Manual Filter, each on its own dial.
13 Beat Effects (delay, echo, trans, filter, flanger, phaser, reverb, robot, crush, roll, reverse roll, up roll, down roll) plus a separate Manual Filter effecter, each with its own TIME and LEVEL/DEPTH dial.
An outboard effector needs SEND/RETURN set correctly, or it stays silent.
A dedicated send/return path (phone jacks) for routing an outboard effector through the mixer’s own effect section. With the effect selector set to SND/RTN but nothing connected to RETURN, the effect produces no sound.
The manual’s own troubleshooting table covers 11 real symptoms.
The manual’s own troubleshooting table opens with a line worth repeating: "Incorrect operations are often mistaken for trouble and malfunctions." It covers 11 symptoms, from no power through BPM measurement and MIDI sync failures, each tied to a specific switch or connection to check before assuming a fault.
Official equipment video
Note: This feature requires an internet connection.
What to watch for
Why there is nothing to update
Short answer. Pioneer DJ’s support page for this model is marked "Archived." No firmware or driver download is listed there, and none exists anywhere this research could reach: the DJM-700 is a fully analogue-control mixer with no USB connection and nothing to update from a computer.
What that means in practice. There is no settings utility, no driver install, and no macOS/Windows compatibility question to chase for this mixer. Every behaviour below is a switch or a dial on the unit itself.
Features, tips and maintenance
Effects, DSP and MIDI
What it is. a four channel digital mixer from the generation before the DJM-800, built around 13 Beat Effects synced to BPM plus a separate Manual Filter effecter.
Effects. 13 Beat Effects (delay, echo, trans, filter, flanger, phaser, reverb, robot, crush, roll, reverse roll, up roll, down roll) plus a separate Manual Filter effecter, each with its own TIME and LEVEL/DEPTH dial.
The processing behind them. A 32 bit digital signal processing path with 24 bit A/D-D/A conversion and 96 kHz sampling.
Send/return. A dedicated send/return path (phone jacks) for routing an outboard effector through the mixer’s own effect section. With the effect selector set to SND/RTN but nothing connected to RETURN, the effect produces no sound.
MIDI. A 5 pin DIN MIDI out jack and fully assignable MIDI control. Syncing an external MIDI sequencer to the mixer needs the sequencer’s own sync mode set to "slave"; a sequencer with no MIDI timing clock support cannot sync at all.
Dimensions and power
Size and weight. 320 mm wide, 378.4 mm deep and 107.9 mm high, weighing 6.6 kg.
Power. AC 110 to 120 V or 220 to 240 V, 50/60 Hz, drawing 33 W.
Troubleshooting and manuals
The manual’s own troubleshooting table
The manual’s own troubleshooting table opens with a line worth repeating: "Incorrect operations are often mistaken for trouble and malfunctions." It covers 11 symptoms, from no power through BPM measurement and MIDI sync failures, each tied to a specific switch or connection to check before assuming a fault.
No sound, or volume too low. Check the input selector matches the connected source, reseat the cables, clean the jacks, and check the rear MASTER ATT switch is not set to -6 dB.
No digital output. The rear sampling-frequency selector has to match the connected digital component.
Sound distorted. Lower the MASTER LEVEL or MASTER ATT, or bring each channel’s TRIM back toward 0 dB.
Cross fader does nothing. Check the CROSS FADER ASSIGN switch is set to the channel in question.
Fader start with a CD player does not work. Turn FADER START on, and connect the CONTROL cable as well as the analogue audio, not just one or the other.
Effects or an outboard effector do not work. Confirm the correct channel is selected, the LEVEL/DEPTH dial is not at minimum, and (for an outboard unit) the effect selector is set to SND/RTN with the effector actually connected.
BPM will not measure, or measures differently than the source player. Bring TRIM closer to 0 dB on every channel; some tracks genuinely cannot be measured, and a small difference from the source player’s own reading is a detection-method difference, not a fault.
A MIDI sequencer will not sync. Its own sync mode has to be set to "slave," and a sequencer with no MIDI timing clock support cannot sync to this mixer at all.
Official downloads and documents
Go to Pioneer DJ for the files themselves. We link their pages instead of hosting a copy, because a manual copied here is a snapshot of release day and theirs is the one that stays current.
Frequently asked questions
Quick answers
- Is the DJM-700 discontinued?
- Its support page is archived. There is no firmware or driver for it, because it is a fully analogue-control mixer.
- Is there a firmware or driver update for it?
- No. Pioneer DJ’s support page for this model is marked "Archived." No firmware or driver download is listed there, and none exists anywhere this research could reach: the DJM-700 is a fully analogue-control mixer with no USB connection and nothing to update from a computer.
- What effects does it have?
- 13 Beat Effects (delay, echo, trans, filter, flanger, phaser, reverb, robot, crush, roll, reverse roll, up roll, down roll) plus a separate Manual Filter effecter, each with its own TIME and LEVEL/DEPTH dial.
- How do I use an outboard effector with it?
- A dedicated send/return path (phone jacks) for routing an outboard effector through the mixer’s own effect section. With the effect selector set to SND/RTN but nothing connected to RETURN, the effect produces no sound.
- Why won't the BPM measure correctly?
- Bring TRIM on every channel back toward 0 dB first; some source material genuinely cannot be measured, and a small mismatch against a connected player's own reading is a difference in detection method, not a fault.
- What are its dimensions and weight?
- 320 mm wide, 378.4 mm deep and 107.9 mm high, weighing 6.6 kg.
- What is its successor?
- DJM-800, still covered on this site as a full Legacy field manual.
Looking for its successor? See the DJM-800, also covered as a full Legacy field manual. More legacy Pioneer DJ equipment: the full archive index.
Playing soon and it is not working?
Start Emergency ModeWhere this sits in the line
- Next generation DJM-800
Pioneer DJ All brands Knowledge base FAQ and Fixes Dictionary
Keep the Emergency Card
We will email you the printable PDF so it is on your phone before the next dark booth. Occasional notes that save gigs. No spam, unsubscribe in one click.
Register and receive itRegistering is free and counts everywhere on Save My Gig. We send a confirmation email first. Your address is stored with Brevo, our email provider. Unsubscribe any time. Privacy
Sources: Pioneer DJ's own DJM-700 product page, Pioneer DJ's archived DJM-700 support page (marked Archived), and the DJM-700-S/DJM-700-K operating instructions manual, checked 26 October 2026. No release year could be confirmed from a source that did not doubt itself, so none is stated. Specifications theirs, priorities ours.