Released 2017 Reviewed: 22 October 2026

SL-1200GR, field manual

Technics SL-1200GR direct drive turntable, top view

Booth briefing. The SL-1200GR is the reference-class member of Technics' SL-1200 line, released in 2017 and carrying forward the engineering of the SL-1200G in the classic SL-1200 case. It is a direct-drive turntable built for a listening room rather than a booth: a single-rotor coreless motor gives it the highest starting torque of the current SL-1200s, turning a two-layer platter designed to damp resonance. In the line it sits between the SL-1200MK2 and the SL-1200MK7, the hi-fi deck in the family where the MK7 is the one built for DJs.

Fast Lane

SL-1200GR: equipment profile

A reference-class direct drive turntable in Technics’ SL-1200 line, with a single-rotor coreless motor and a two-layer platter.

What comes out
Phono out on one pin-jack set, one earth terminal. No USB, no line switch. Rumble 78 dB, IEC 98A weighted.
Output level
Set by the cartridge fitted. Technics publish no output figure.
Staying in time
33 1/3, 45, 78 rpm. Pitch ±8 or ±16 per cent. Torque 2.2 kg-cm. Wow and flutter 0.025 per cent.
Power
120 V AC at 60 Hz. 11 W consumed, about 0.2 W in standby.
Dimensions and weight
45.3 cm wide, 37.2 deep, 17.3 tall (17.8 × 14.6 × 6.8 in). 11.5 kg / 25.4 lb.
Released
2017

us.technics.com, the SL-1200GR product page, Specifications table and feature description.

The five things that decide your gig

The SL-1200GR in five points, each linked to its section.

The highest starting torque of any SL-1200 here.

It comes from the single-rotor coreless motor.

The motor and the platter

It is a listening deck, not a scratch deck.

There is no reverse play.

Where the GR sits

Two cartridge weight windows.

The auxiliary weight, supplied in the box, decides which one applies.

Fitting a cartridge

All three speeds are standard.

33 1/3, 45 and 78 rpm.

Speeds and pitch

Technics publish one rumble figure, not two.

The MK2 manual gives a weighted and an unweighted one.

Reading the spec sheet straight

Official equipment video

Note: This feature requires an internet connection.

Features explained

The motor and the platter

The motor. The SL-1200GR runs a single-rotor, surface-facing coreless direct drive motor, which Technics say eliminates cogging (rotation irregularity) because there is no iron core. Technics describe advanced motor control for high starting torque and high-speed rotation stability.

What that buys in practice. On the GR, starting torque comes out at 2.2 kg-cm, and start-up takes 0.7 seconds from standstill to 33-1/3 rpm. Wow and flutter measure 0.025 % WRMS, and on rumble Technics publish one figure rather than two: 78 dB, IEC 98A weighted. No separate signal-to-noise figure is published.

The platter underneath it. Aluminium diecast, 332 mm diameter, approximately 2.5 kg including the rubber sheet, in a two-layer construction with deadening rubber that Technics say reduces unwanted resonance. Technics says every platter is balanced at the factory with high-precision equipment, the kind of detail that matters more on a deck meant to be listened to closely than one built to survive a club night.

Speeds and pitch

Speeds. The SL-1200GR plays 33-1/3, 45 and 78 rpm, all three standard. The MK2 has no 78 rpm at all; the MK7 and the MKX add it behind a setting.

Pitch. Plus or minus 8 and plus or minus 16 per cent, the same two ranges the MK7 carries.

Tonearm and insulation

The arm. The SL-1200GR's tonearm is universal static balance, lightweight aluminium, with a gimbal-suspension bearing housing and what Technics call a high-damping effect.

Geometry. 230 mm effective length, 15 mm overhang, 22 degrees offset angle, arm height 0 to 6 mm, tracking error within 2 degrees 32 minutes at the outer groove and 0 degrees 32 minutes at the inner groove of a 30 cm record.

Sensitivity. Technics state initial-motion sensitivity of 5 mg or less, which they attribute to manual assembly by skilled workers rather than to the geometry alone.

Isolation. High-damping silicon insulators, on a body Technics describe as high-rigidity.

Connections, power and what is in the box

Output. The SL-1200GR carries one PHONO pin-jack output and one earth terminal, no USB and no line switch: a phono input or a preamp is required.

Power. 120 V AC, 60 Hz, 11 W on the North American model, approximately 0.2 W in standby.

Size and weight. 453 x 173 x 372 mm (W x H x D), approximately 11.5 kg.

In the box. Turntable sheet, dust cover, EP record adaptor, balance weight, auxiliary weight, headshell, overhang gauge, cartridge screw set, PHONO cable, PHONO earth lead, AC power cord and owner's manual.

What to watch for

Where the SL-1200GR sits, and what it is not

Not a club deck. The SL-1200GR is not pitched at a booth. Technics say the design builds on the SL-1200G, released in 2016. There is no reverse play and no performance feature beyond the three standard speeds, which separates it from the SL-1200MK7 and the SL-1210MKX, both built with club and touring use stated outright.

The tonearm is tuned for sensitivity, not abuse. The figure is under Tonearm and insulation.

Fitting a cartridge to the SL-1200GR: two weight windows, one switch

Without the auxiliary weight. The SL-1200GR takes 5.6 to 12.0 g without the auxiliary weight, or 14.3 to 20.7 g including the headshell.

With the auxiliary weight fitted. 10.0 to 16.4 g with the auxiliary weight fitted, or 18.7 to 25.1 g including the headshell.

It ships in the box. Technics include the auxiliary weight as standard, so moving between the two windows is a swap rather than a separate purchase. Stylus pressure dials 0 to 4 g, direct reading, the same range as the MK7 and wider than the MK2's 0 to 2.5 g.

Headshell and mounting. Approximately 7.6 g, on a 1.2 mm diameter four-pin terminal lug, JIS 12.7 mm (half-inch) spacing.

Frequently asked questions

Questions about the SL-1200GR

Is the SL-1200GR built for DJ booths?
Not the way the SL-1200MK7 is. Technics pitch the GR as a reference-class listening deck, and it has no reverse play.
How does its starting torque compare to the MK2 and MK7?
Higher. 2.2 kg-cm against 1.5 kg-cm on the MK2 and 1.8 kg-cm on the MK7.
Does it play 78 rpm?
Yes, standard, along with 33-1/3 and 45.
What cartridge weight does it take?
Two ranges, one without the auxiliary weight and one with it. Both are listed under Fitting a cartridge.
Where does the SL-1200GR sit against the SL-1200G it replaced?
It carries the SL-1200G's engineering forward rather than starting the design over.

Where this sits in the line

Related turntables

Commonly paired with

What you usually find beside it in working booths, from club, festival and rental installs rather than from a manufacturer document.

Technics All brands Knowledge base FAQ and Fixes Dictionary

Keep the Emergency Card

We will email you the printable PDF so it is on your phone before the next dark booth. Occasional notes that save gigs. No spam, unsubscribe in one click.

Register and receive it