Released 2016 Reviewed: 18 October 2026

PLX-500, field manual

Pioneer DJ PLX-500 direct drive turntable, top view

Booth briefing. The PLX-500 is the entry-level direct-drive turntable in Pioneer DJ's PLX line, for DJs starting on vinyl and for record collectors. It plays 33 1/3, 45 and 78 rpm, takes VM or MM cartridges, and has a switch on the back that lets it feed either a mixer's phono input or powered speakers directly. A USB port records vinyl to a computer with the free rekordbox, with no driver to install, which makes it a way to digitise a collection as well as to play it. It is a turntable for learning and for listening as much as for the booth.

Fast Lane

PLX-500: equipment profile

The entry-level direct-drive turntable of the PLX line: 10.7 kg and 450 mm wide, with a USB port that records to a computer.

What comes out
PHONO at 2.5 mV or LINE at 150 mV, chosen by the PHONO/LINE switch on the rear panel.
Output level
Fitted VM cartridge, 3.0 g to 4.0 g. Arm takes VM or MM up to 9.5 g, not MC. Readout 0 to 4.0 g in 0.1 g steps.
Staying in time
Servo type direct drive on a 3-phase brushless DC motor, 33 1/3, 45 and 78 rpm. Pitch plus or minus 8 per cent. Starting torque 1.6 kg-cm or more, start time 1 second or less, wow and flutter 0.15 per cent or less WRMS and signal to noise 50 dB or more. Electronic brake, 332 mm aluminium die-cast platter.
Computer and driver
USB Type-B, Mac or Windows. No driver software. Recording needs rekordbox 4.2.1 or later.
Power
AC 110 to 120 V or 220 to 240 V at 50/60 Hz, 11 W, cord supplied. 450 mm wide, 367.5 mm deep, 158.5 mm tall, 10.7 kg.
Dimensions and weight
45 cm wide, 36.8 deep, 15.8 tall (17.7 × 14.5 × 6.2 in). 10.7 kg / 23.6 lb.
Released
2016

PLX-500 Operating Instructions DRH1378E, Specifications and Troubleshooting.

The five things that decide your gig

The PLX-500 in five points, each linked to its section.

Set the PHONO/LINE switch for what you plug into.

A wrong setting is the first thing to check for low or distorted volume.

The PHONO/LINE switch

Cartridge choice is limited to VM and MM.

A cartridge of 5 g or less needs the shell weight.

Cartridges

A mixer with no PHONO input? Switch to LINE and use a LINE input.

Leave the switch on PHONO whenever a phono input is free.

Plugging into a DJ mixer

USB records to a computer, and no driver is needed.

It records only: the USB port does not control software.

Recording over USB

Cold from the car? Leave it off for 1 to 2 hours first.

If it misbehaves for no reason, switching it off for one minute and on again clears static.

Cold rooms and static

Official equipment video

Note: This feature requires an internet connection.

What to watch for

The PHONO/LINE switch

Short answer. The PLX-500 has a PHONO/LINE switch on the rear panel, and it decides what the deck can be plugged into. PHONO, 2.5 mV at 1 kHz, is for a DJ mixer's PHONO input or an amplifier's PHONO terminal. LINE, 150 mV at 1 kHz, is for powered speakers or any LINE input. The manual cautions against one mistake: feeding a phono-level input from the deck while the switch sits on LINE. Low or distorted volume is listed against this switch in its troubleshooting table.

Cartridges: VM and MM only

Short answer. The PLX-500 ships with a headshell and cartridge already fitted, and the stylus pressure for that cartridge is 3.0 g to 4.0 g. The tone arm accepts a cartridge of up to 9.5 g, and with one of 5 g or less the supplied shell weight is required. Only VM and MM types fit; the manual rules out MC. When you fit another cartridge, the overhang scale puts the stylus tip 53 mm from the tone arm attachment part, and the arm height and arm lifter height are set again to suit it.

Compatibility and setup

Plugging into a DJ mixer

Short answer. Use a PHONO input, switch on PHONO. A mixer with no PHONO input needs the switch on LINE and a LINE input instead, because the PHONO setting cannot give such a mixer enough volume or sound quality. Into powered speakers the switch is also on LINE, and the included audio adaptor cable converts the stereo pin plug to a stereo mini plug where the speakers need it. Make every connection first and plug the power cord in last.

Recording over USB

Short answer. The PLX-500 has a USB Type-B port for recording records to a Mac or Windows computer, and the manual states that USB driver software is not required. Recording is done in the free rekordbox, version 4.2.1 or later, and the manual sends you to the rekordbox operating instructions for the steps. Its activation note covers rekordbox dj, rekordbox dvs and rekordbox video only. The port carries the recording to the computer, and the PHONO/LINE jacks stay the way the deck plays into a mixer or speakers.

Power

Short answer. The PLX-500 runs from AC 110 V to 120 V or 220 V to 240 V at 50 Hz or 60 Hz and draws 11 W, through the included power cord, which the manual says must be the one used. The POWER switch does not cut all power from the outlet, so the cord is what shuts the unit down completely.

Speed. The TEMPO slider covers plus or minus 8 per cent, and four strobe rows, lit by a red LED, read the speed for 50 Hz and 60 Hz mains at 33 1/3 and 45 rpm.

Dimensions and weight

Width: 450 mm / 17.72 in

Height: 158.5 mm / 6.24 in

Depth: 367.5 mm / 14.47 in

Weight: 10.7 kg / 23.6 lb

Sources. Pioneer DJ's own documentation, document DRH1378E, for width, height, depth and weight.

If something goes wrong

No sound, or quiet sound

Short answer. On a PLX-500 that gives no sound or small sound, the manual's checks are three: are the audio cables properly connected, are the terminals and plugs dirty, and is the headshell attached properly. Left and right reversed means the connections of the equipment are reversed, or the headshell lead wires are, and the colours on the cartridge terminals say which is which. A low hum during playback is looked for first in a fluorescent lamp or its power cord lying near the connection cord, to be placed as far away as possible.

A stylus that jumps

Short answer. On a PLX-500 that skips, the manual lists the same set of causes in the same order: the stylus pressure, a warped or scratched record, a stylus tip carrying dust, the anti-skating setting and the arm height. A stylus that will not come down on the record is the stylus pressure or an arm that is not horizontally balanced, and an arm that stops part way across is a scratch on the record or the arm touching something. Scratching changes two of those settings on purpose: the anti-skating dial and the arm height are set to match the play action.

Cold rooms and static

Short answer. A PLX-500 that was carried in from the cold may not play, and the manual treats it as a condition and not a fault. Water droplets can form inside the unit on its moving parts, and the remedy is to let it stand for 1 to 2 hours at room temperature without turning on the power. Static electricity and other outside influences can also stop the deck behaving properly, and the manual's recovery for that is to turn the power off, wait 1 minute and turn it back on. Never clean the dust cover while a record is playing, because static can pull the tone arm toward it.

Features, tips and maintenance

Firmware

There is no firmware for the PLX-500. Pioneer DJ's help centre page for it lists the instruction manual only: no firmware download and no driver.

Official documentation. Pioneer DJ's help centre page for this model →
Found an entry we have missed? Tell us and we will add it.

Taking one to a gig

Check the switch before you plug in. What each setting is for is under The PHONO/LINE switch.

Bring the right cartridge. The limits are under Cartridges: VM and MM only.

Let it warm up. After a cold journey, give it the time set out under Cold rooms and static.

Take the stylus cover and arm clamper off before you play, and put the clamper back on to pack it.

Firmware, drivers and manuals

Official downloads and documents

Go to Pioneer DJ for the files themselves. We link their pages instead of hosting a copy, because a manual copied here is a snapshot of release day and theirs is the one that stays current.

Manuals. Official Pioneer DJ manual page →

Broken link? Let us know and we'll fix it.

Frequently asked questions

Quick answers

What does the PHONO/LINE switch on the PLX-500 do?
It sets the output level: 2.5 mV on PHONO, 150 mV on LINE.
Can I use an MC cartridge on a PLX-500?
No. Fit a VM or MM cartridge instead.
My mixer has no phono input. Can I still use it?
Yes, on the LINE setting and into a LINE input.
Does the PLX-500 need a USB driver?
No. The deck needs no driver software.
How do I play 78 rpm records?
Press 33 and 45 together.
Is there a firmware update for it?
No. None exists for this model.

Related turntables

Commonly paired with

What you usually find beside it in working booths, from club, festival and rental installs rather than from a manufacturer document.

Pioneer DJ All brands Knowledge base FAQ and Fixes Dictionary

Playing soon and it is not working?

Start Emergency Mode

Keep the Emergency Card

We will email you the printable PDF so it is on your phone before the next dark booth. Occasional notes that save gigs. No spam, unsubscribe in one click.

Register and receive it

Sources: Pioneer DJ's PLX-500 Operating Instructions DRH1378E, read in full, from the help centre page for the model, checked 18 October 2026. Specifications theirs, priorities ours.