Released 2016 Reviewed: 18 October 2026

TORAIZ SP-16, field manual

Pioneer DJ TORAIZ SP-16 standalone sampler and sequencer control panel, top view

Booth briefing. The TORAIZ SP-16 is a production instrument: a standalone sampler and sequencer in Pioneer DJ's TORAIZ range, with 16 pads and 16 tracks, which Pioneer DJ also document for live and DJ performances. It holds its sounds on internal storage that ships with a library of sound sources, loads more from USB storage, and can lock to a DJ's decks over PRO DJ LINK so its patterns stay in time with the players. That link keeps them in time, but it does not let the decks control the SP-16 or the SP-16 control the decks. In a DJ set it adds live beats, loops and chopped samples on top of the mix, played from its own pads.

Fast Lane

TORAIZ SP-16: equipment profile

A 16 track standalone sampler and sequencer with a Dave Smith analogue filter and a 7 inch touch screen.

What comes out
OUT 1-2 is the MASTER pair on quarter-inch TS jacks and OUT 3-8 add three more assignable stereo pairs, with PHONES on a quarter-inch stereo jack. Two quarter-inch TS INPUT jacks take a line signal, with an INPUT LEVEL control and a SOFT LIMIT button in front of the converter.
Output level
Rated output is +16 dBu into 10 kilohms with 680 ohms of output impedance, and maximum input is +16 dBu. Headphones are rated 100 mW per side into 32 ohms. Sampling is 44.1 kHz, 24-bit in and 32-bit out.
Drives and cards
Type A USB port on the top panel, FAT16 or FAT32 only, 5 V at 500 mA. 8 GB of internal flash, 2 GB of it Loopmasters sound sources at delivery.
Staying in time
MIDI IN and MIDI OUT/THRU on 5-pin DIN, MIDI over USB-B, and a LINK LAN port for PRO DJ LINK.
Computer and driver
USB Type-B port for USB MASS STORAGE MODE and MIDI. Driver: N/A.
Power
The included AC adaptor only, DC 12 V at 3 A, 2 A drawn. No battery or USB bus power.
Dimensions and weight
43.6 cm wide, 26.1 deep, 7.4 tall (17.2 × 10.3 × 2.9 in). 3.2 kg / 7.1 lb.
Released
2016

The TORAIZ SP-16 Operating Instructions DRI1377B, which describe firmware 1.00, the Quick Start Guide DRH1360B for its specification table, and Pioneer DJ's firmware ver1.6 addendum.

The five things that decide your gig

The TORAIZ SP-16 in five points, each linked to its section.

Never pull a USB device while the USB indicator is lit or flashing.

A skipped eject can leave the drive unreadable.

Ejecting USB without losing data

Format the drive FAT16 or FAT32. exFAT and NTFS are not on the list.

No hub: the drive goes straight into the Type A slot.

Which drives and files it reads

The printed manual describes firmware 1.00; the unit runs up to 1.60. Read the version first.

On an old unit the menus may not match the manual.

The manual and the firmware

To follow a DJ's decks it needs BEAT SYNC over PRO DJ LINK.

Check which clock source is selected.

Syncing to the decks

A dark display after a long idle is auto standby, not a dead unit.

One press of USB STOP/WAKE UP wakes it.

The display that went dark

Official equipment video

Note: This feature requires an internet connection.

What to watch for

Ejecting USB without losing data

Short answer. Hold the USB STOP button on the SP-16 for at least two seconds and wait for the USB indicator before pulling a USB device out. The manual's warning is that removing the device, or switching the unit off, while the USB indicator is lit or flashing can delete the management data held in the unit and leave the device unreadable. The same applies to the cable while the SP-16 is in USB MASS STORAGE MODE and talking to a computer: eject from the computer first, then unplug.

Which drives and files it reads

Short answer. The TORAIZ SP-16 reads USB mass storage devices in the Type A slot on its top panel, formatted FAT16 or FAT32, and the manual lists no other file system, so an exFAT or NTFS drive is not on the supported list. Samples are WAV or AIFF at 44 kHz, and only files in the Samples folder of the TORAIZ folder the unit creates on the device are visible to BROWSE. A hub cannot be used, and a device holding many folders or non-music files takes longer to read.

Compatibility and setup

Syncing to the decks

Short answer. BEAT SYNC needs the LAN cable between the unit's LINK port and the PRO DJ LINK network and firmware newer than the 1.00 its manual was written for, and it follows only tracks that rekordbox has already analysed. From firmware 1.60 the clock source is one SYNC SOURCE SELECT setting with four choices, Internal, PRO DJ LINK, DIN MIDI and USB MIDI, and MASTER PLAYER SELECT on AUTO works only if every PRO DJ LINK player on the network is a compatible model.

The manual and the firmware

Short answer. The TORAIZ SP-16 manual on most shelves, DRI1377B, was written for firmware 1.00, and the machine kept growing until 1.60 in October 2019. Pioneer DJ's help centre carries an addendum covering 1.10 to 1.60, dated 6 February 2020, which adds PRO DJ LINK sync, MIDI IN and OUT, an LFO, new insert effects, live sampling from the INPUT terminals and a second insert effect, and removes the older MIDI I/F SELECT setting. On a unit with old firmware the manual and the menus disagree, so read the version off the UTILITY screen first.

Power, and the cord hook

Short answer. The TORAIZ SP-16 runs from the included AC adaptor, DC 12 V at 3 A, and draws 2 A. There is no battery and no USB bus power, and the manual says the sound is interrupted if the adaptor lead is disconnected during playback, so use the cord hook on the rear panel before you start. The USB-B port is the connection to a computer, for USB MASS STORAGE MODE and MIDI.

Dimensions and weight

Width: 436.5 mm / 17.19 in

Height: 74.3 mm / 2.93 in

Depth: 261.2 mm / 10.28 in

Weight: 3.2 kg / 7.1 lb

Sources. Pioneer DJ's own documentation, document DRH1360B, for width, height, depth and weight.

If something goes wrong

The display that went dark

Short answer. The SP-16 ships with auto standby switched on. After four hours with no control touched, no track level lit, nothing playing, no PRO DJ LINK connection, no USB device in the slot and no USB mass storage mode, it drops to standby and the display goes dark. The USB STOP/WAKE UP button lights during standby, and pressing it cancels it. AUTO STANDBY in the UTILITY menu turns the function off. A dark SP-16 that has simply been idle is waiting, not dead.

Features, tips and maintenance

What the firmware record says

Pioneer DJ publish firmware for the TORAIZ SP-16 as an addendum, not as a change history. The help centre page lists a Firmware ver1.6 operating instructions addendum dated 6 February 2020, which describes what each version from 1.10 to 1.60 added, plus a list of manual corrections dated 3 October 2019.

Official documentation. Pioneer DJ's help centre page for this model →
Found an entry we have missed? Tell us and we will add it.

Taking one to a gig

Check the firmware before you trust the manual. The route is under The manual and the firmware.

Eject before you unplug. The steps are under Ejecting USB without losing data.

Pack the drive before you arrive. FAT32, with the samples already in the folder BROWSE reads.

Know the standby. See The display that went dark.

Firmware, drivers and manuals

Official downloads and documents

Go to Pioneer DJ for the files themselves. We link their pages instead of hosting a copy, because a manual copied here is a snapshot of release day and theirs is the one that stays current.

Manuals. Official Pioneer DJ manual page →

Broken link? Let us know and we'll fix it.

Frequently asked questions

Quick answers

How do I remove a USB device from the TORAIZ SP-16 safely?
Press and hold USB STOP; the indicator tells you when it is safe.
Which USB drives does it read?
FAT16 or FAT32 only, in the Type A slot, with no hub.
Why does my manual not match the menus?
The manual describes firmware 1.00 and the menus have moved on.
How does it sync to CDJs?
Through BEAT SYNC, wired to the LINK port.
The display is dark. Is it dead?
Probably not: press USB STOP/WAKE UP.
Is there a firmware update for it?
Yes, up to 1.60, described in the addendum rather than a change history.

Related samplers

Commonly paired with

What you usually find beside it in working booths, from club, festival and rental installs rather than from a manufacturer document.

Pioneer DJ All brands Knowledge base FAQ and Fixes Dictionary

Playing soon and it is not working?

Start Emergency Mode

Keep the Emergency Card

We will email you the printable PDF so it is on your phone before the next dark booth. Occasional notes that save gigs. No spam, unsubscribe in one click.

Register and receive it

Sources: Pioneer DJ's TORAIZ SP-16 Operating Instructions DRI1377B, read in full, with the quick start guide DRH1360B and the firmware addendum for versions 1.10 to 1.60 on the help centre page, checked 18 October 2026. Specifications theirs, priorities ours.