Released 2019 Reviewed: 16 October 2026

DJ-707M, field manual

Roland DJ-707M DJ controller, top view

Booth briefing. The DJ-707M is the DJ controller in Roland's Serato family built for running an event, and Roland also describes it as a livestreaming sound console, audio interface and loudspeaker management system. It uses the DSP of Roland's digital audio consoles, with 10 scene memories, processing on the master, booth and zone outputs, and feedback suppression. Roland built it for DJs who also run the event: two computer ports allow a backup laptop or a changeover between DJs, and the mic section takes up to four microphones. It is ready for a Serato DVS upgrade.

Fast Lane

DJ-707M: equipment profile

Roland's Serato DJ controller built for running an event, with two computer ports and a mic section.

Software
Serato DJ Pro.
What it unlocks
Channel Effects and Vocal Effects. Scene backup and restore.
Without a computer
No music without a computer. The mixer inputs still work.
Sound out
MASTER 1: XLR +6 dBu. MASTER 2: RCA +0 dBu. BOOTH: TRS +6 dBu. ZONE: RCA +0 dBu.
Power
Supplied AC adaptor, 2,000 mA. Weight 3.5 kg without it. Auto Off defaults to 20 minutes.
What the computer needs
Two PC ports, A and B, USB type B. Roland driver required. MIDI OUT.
Dimensions and weight
47.4 cm wide, 33.1 deep, 7.3 tall (18.7 × 13 × 2.9 in). 3.5 kg / 7.7 lb.
Released
2019

Roland's own DJ-707M specification page, the owner's manual and the update history to ver. 1.05.

DJ-707M: five things to know

The DJ-707M in five points, each linked to its section.

Two computer ports, chosen per deck.

It is the feature this unit exists for.

Two computers, one unit

ZONE OUT feeds a second room at its own level.

It is a second feed, not a spare master.

Outputs and levels

By default it switches itself off after 20 minutes.

The setting to change first.

Power and Auto Off

Two XLR mic inputs, and up to four microphones.

Vocal Effects are separate from Channel Effects.

What you can plug into it

It has no TR drum section.

It trades the drum machine for sockets.

DJ-505

Official equipment video

Note: This feature requires an internet connection.

Connections and setup

Two computers, one unit

Short answer. Two PC ports on the rear panel, A and B, both USB type B. The unit controls whichever computer's button is lit, and the choice is made separately for the left deck and the right deck.

Changeover. A changeover on a single-port controller means unplugging one laptop and plugging in another, in front of the room, with the music stopped. Here both machines stay connected and the handover is a button.

Driver. Roland's own driver is required on both machines, published to 1.0.4 for macOS Sonoma 14 or later and 1.0.1 for Windows 10 and 11, and it is a separate download from the system program.

USB type B. The older square connector. A recent laptop needs an adaptor or a B-to-C cable.

Outputs and levels

Short answer. MASTER OUT 1 on balanced XLR at +6 dBu, MASTER OUT 2 on RCA at +0 dBu, BOOTH OUT on balanced quarter-inch TRS at +6 dBu, and ZONE OUT on RCA at +0 dBu. Headphones take a quarter-inch and a mini jack.

ZONE OUT. It has its own level knob on the panel, so the dining room or the bar runs quieter than the floor from the same controller. No second mixer, no second DJ.

Levels. Roland publishes every one of those levels. Four figures, which is rare for the brand. The house channel can be set from the number.

At setup. Four outputs means four decisions. Master to the house, booth to your monitor, zone to the other room, and MASTER OUT 2 free for a recorder. Write down which is which before the room fills.

What you can plug into it

Short answer. Four RCA inputs that accept phono level, with a PHONO GROUND terminal. Two XLR microphone inputs. An AUX input on both quarter-inch TRS and a stereo mini jack.

Four microphones. The quarter-inch AUX IN jacks on the front panel have a switch that sets them to MIC level. With the two XLR inputs that makes four microphone inputs, which Roland gives as the unit's maximum.

At an event. A speech on one mic and a toast on the other, the client's phone on the AUX mini jack, a turntable on a channel, and your own two laptops on PC A and PC B. Very little needs to be refused.

Ground post. If a deck is on the CH 1 or CH 2 INPUT jacks, its earth wire goes to PHONO GROUND. Without it there is hum, and the hum reads as a fault in the unit.

Mic gain. 1.03 of February 2020 adjusted the initial value of MIC GAIN, so an un-updated unit starts from a different place than the manual's screenshots suggest.

Power and Auto Off

Short answer. The supplied AC adaptor, drawing 2,000 mA. Not bus-powered, and Roland's published weight of 3.5 kg excludes the adaptor.

Auto Off. From firmware 1.05 of March 2025 the unit powers itself down after 20 minutes without playback or a control being touched.

Why it matters at events. A club DJ plays continuously. An events DJ stops for the speeches, the first dance, the cake and the buffet. This is the unit most likely to meet that timer, and a controller that has switched itself off presents as a controller that has died.

Pack the brick with the unit. There is no second way to power it, so the adaptor is part of the instrument.

What to watch for

Firmware

Short answer. Roland publishes four releases for the DJ-707M. There is no bad version to avoid on this unit.

1.05, March 2025. The default Auto Off time became 20 minutes. Not a fault: see Power and Auto Off. It is the change that matters most for anyone working events.

1.04, February 2022. A version-number change for management reasons. Roland states product specifications are unaffected.

1.03, February 2020. Roland file the MIC GAIN change as a functionality improvement rather than a fix.

1.02, August 2019. Channel Effects and Vocal Effects were added, along with scene backup and restore. On a unit that moves between venues, being able to recall a setup rather than rebuild it is worth the update on its own. Its bug-fix line says only that minor bugs have been fixed, with no symptom.

Professional tips

Before the gig

Turn Auto Off off before the guests arrive. It is in the system settings.

Set up both computers at the start, not at the handover. The point of PC A and PC B is that the second laptop is already connected and tested while the first is still playing.

Check the zone level with the room empty and again when it fills. A second room set by ear at setup is often wrong later, and it is the feed nobody is standing next to.

Carry two USB type B cables and two adaptors. A borrowed cable at an event is rarely available.

Firmware, drivers and manuals

Official downloads and documents

Go to Roland for the files themselves. We link their pages instead of hosting a copy, because a manual copied here is a snapshot of release day and theirs is the one that stays current.

The system program and the driver are separate downloads, and the version of record is 1.05. Roland publish the owner's manual and the Startup Guide in seven languages each, plus a MIDI implementation chart.

Frequently asked questions

Quick answers

Can two DJs use a DJ-707M without unplugging?
Yes. Each deck can be pointed at either computer.
My DJ-707M turned itself off during the speeches. Why?
Auto Off, which defaults to 20 minutes.
What is ZONE OUT for?
Sending sound to a second room, such as a bar.
How many microphones can I use?
Two on XLR, and four if the front AUX IN jacks are switched to MIC.
Does it have the TR drum machine?
No. That is the DJ-505.
Can I connect turntables?
Yes, on the four RCA inputs, with the earth wire on PHONO GROUND.
What are the output levels?
The balanced outputs run at a higher level than the RCA ones.
Does the DJ-707M have known bugs?
None known.
Does it run on USB power?
No. It needs the AC adaptor.
Which software does it use?
Serato DJ Pro, downloaded separately.

Playing soon and it is not working?

Start Emergency Mode

Keep the Emergency Card

We will email you the printable PDF so it is on your phone before the next dark booth. Occasional notes that save gigs. No spam, unsubscribe in one click.

Register and receive it

Sources: Roland's product pages and owner's manual for the DJ-707M, and its published update history, checked 16 October 2026. Specifications theirs, priorities ours.